Transmissions
Anti-Vibration Mounts
Ant Vibration Stud Mounts
Type B Bobbin Anti Vibration Mount
Quick Code: BB-357539
Bobbin Type B 16mm OD x 15mm Rubber Metal Anti Vibration Mount
![Bobbin Type B 16mm OD x 15mm Rubber Metal Anti Vibration Mount](https://thumbnails.bearingboys.co.uk/Bobbin_Type_B_16mm_OD_x_15mm_Rubber_Metal_Anti_Vibration_Mount-prod-357539-1.jpg)
![](https://thumbnails.bearingboys.co.uk/Bobbin_Type_B_16mm_OD_x_15mm_Rubber_Metal_Anti_Vibration_Mount-prod-357539-1.jpg)
![](https://thumbnails.bearingboys.co.uk/Bobbin_Type_B_16mm_OD_x_15mm_Rubber_Metal_Anti_Vibration_Mount-prod-357539-2.jpg)
The AMC bobbins are devices for making elastic anchorings or fixings. They can be used in a wide variety of applications, particularly for elastic suspensions and anti vibration isolation of machines and different mechanical organs. Type B bobbins are made of a block of rubber with two parallel metal parts at the end and can be fixed with a combination of nuts and screws. The rubber block may be cylindrical in cases requiring greater load capacity or as a diabolo when greater elasticity is required in all directions.
Depending on the size of the rubber block, the AMC bobbing has more or less elasticity, which is greater particularly in all directions perpendicular to its axis (shear). The bobbing thus makes it possible to make joins which permit major relative movements, up to several millimetres (in the case of heat expansion, chassis deformations, etc.). It serves very well for the vibration isolation of machines where the vibrations are perpendicular to their axis, unless these stresses are too much when applied in this direction.>
Applications
Suitable for installation on small motor-pumps, motor-ventilators, driers, sieves, compactors, washing machines, electrical motors, on-board control panels, measuring apparatuses, control cabinets, microphones, fluorescent tubes, etc.
Its elasticity is much greater in all the directions parallel to the armatures than in the perpendicular direction. The rubber works based on compression or shear depending on the direction it is placed at installation time. This direction is made according to the use and the objective. It is therefore installed with nuts or screws depending on the model chosen, with one part attached to the fixed chassis and the other to the machine to be suspended.